EC135 Transmission Hydraulic Pump Drive Seal Installer and Puller MSRP: Was: Now: $800.00 Add to Cart
UV Flashlight for Transmission and Engine Oil Leak Checks UV flashlight for detecting oil leaks. Works great in the daytime (with cowlings on), works even better at night. Make sure you wash off your aircraft well before performing a ground run leak check with this light. It will light up ALL your residual oil... MSRP: Was: Now: $30.00 Add to Cart
1/4" Drive Breaker Bar 1/4" drive breaker bar that is perfect for our special tools and replaces a ratchet that is always rotating. You should be fighting the helicopter, not your tools. Works great with the 407 Hydraulic Pump Wrenches. MSRP: Was: Now: $15.00 Add to Cart
3/4" Drive Ratchet *EXCESS INVENTORY* 3/4" Drive Ratchet for a price you won't find anywhere else. These are extras from a kit we purchase and do not use the ratchet. So we are offering it reasonably priced. MSRP: Was: Now: $50.00 Add to Cart
Pin Gauges For Inspecting Splines All pin gauges are 2 inches long unless otherwise specified. Pin gauges can be modified for different lengths for an extra fee. If you do not see the diameter pin you need, let us know. We can have them here the very next day. We try to keep all... MSRP: Was: Now: $20.00 - $100.00 Choose Options
10X Magnifying Glass We chose this model of magnifying glass because the cup is setup for the correct focal distance. Just place the magnifying glass on the object you are trying to inspect and you are focused. No fighting the loupe trying to figure out the correct focus... MSRP: Was: Now: $20.00 Add to Cart
EC135 Tail Rotor Inspection EASB EC135-64-11-0001 Work Aid One of the tools required for performing inspection per EC135 EASB EC135-64-11-0001 EASA AD 2024–0028–E FAA AD 2024–04–10 MSRP: Was: Now: $550.00 Add to Cart
Dykem Cross Check Torque Stripe We have this torque stripe in orange only MSRP: Was: Now: $10.00 Add to Cart
EC135 Transmission Hydraulic Pump Drive Seal Installer and Puller This tool is for removing and installing the seal for the hydraulic pump on the transmission. The aluminum piece is the seal installer and the slide hammer is for removing the seal. Comes with protective case and foam... MSRP: Was: Now: $800.00 Add to Cart
Grease Fitting - Straight These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in. MSRP: Was: Now: $15.00 Add to Cart
Grease Fitting - 90° These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in. MSRP: Was: Now: $20.00 Add to Cart
90° Grease Coupler I recently found this 90 degree grease coupler that works great on hard to access grease fittings.Works really well on the oil cooler blower bearings on the Bell 407. It slides in from the side when straight on access is difficult or next to impossible. MSRP: Was: Now: $16.00 Add to Cart
Torque Adapters 1/4" Drive Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter. SAE: The standard set consists of 1/4", 5/16", 3/8", &... MSRP: Was: Now: $50.00 - $170.00 Choose Options
EC135 & EC145 Hydraulic Module Plunger Work Aid This hydraulic module plunger work aid is designed for the aft facing hydraulic module on the 145 series aircraft. The older style plunger work aid is too large to fit between the transmission and hydraulic module. This work aid is required if you want... MSRP: Was: Now: $235.00 Add to Cart
EC135 Servo Pack Holding Fixture EC135 servo pack holding fixture MSRP: Was: Now: $1,500.00 Add to Cart
