Robinson

Rolls-Royce 250/300 St. Gobain Seal Remover

Slide hammer to remove the St Gobain seal on both the RR250 and RR300.

Rolls-Royce 250 Engine Maintenance Stand

Maintenance stand that can rotate engine 360 degrees. Maintenance stand can be taken apart for transportation or storage.

Rolls-Royce 300 Carbon Seal Holder

New tool from Rolls-Royce to hold the carbon seal.

UV Flashlight for Transmission and Engine Oil Leak Checks

UV flashlight for detecting oil leaks. Works great in the daytime (with cowlings on), works even better at night. Make sure you wash off your aircraft well before performing a ground run leak check with this light. It will light up ALL your residual oil...

1/4" Drive - 12 point Universal/Swivel Sockets SAE & METRIC

We have located some quality swivel sockets at an affordable price that we are happy to offer here! They are made by Genius Tools. SAE (6pc) set consists of 1/4", 5/16", 3/8", 7/16", 1/2", & 9/16" Metric (9pc) set consists of 6mm, 7mm, 8mm, 9mm,...

1/4" Drive Breaker Bar

1/4" drive breaker bar that is perfect for our special tools and replaces a ratchet that is always rotating. You should be fighting the helicopter, not your tools. Works great with the 407 Hydraulic Pump Wrenches.  

3/4" Drive Ratchet *EXCESS INVENTORY*

3/4" Drive Ratchet for a price you won't find anywhere else.   These are extras from a kit we purchase and do not use the ratchet. So we are offering it reasonably priced.

Pin Gauges For Inspecting Splines

All pin gauges are 2 inches long unless otherwise specified.  Pin gauges can be modified for different lengths for an extra fee. If you do not see the diameter pin you need, let us know. We can have them here the very next day. We try to keep all...

Pitot Tube Cover

Simple Pitot Tube Cover

10X Magnifying Glass

We chose this model of magnifying glass because the cup is setup for the correct focal distance. Just place the magnifying glass on the object you are trying to inspect and you are focused. No fighting the loupe trying to figure out the correct focus...

Ultimate Swing Wrench Kit

Ultimate Swing Wrench Kits contains 28 pieces. They are: T-handle, Screwdriver handle, and curved handle Open End: 1/4, 5/16, 3/8, 7/16, 1/2, & 9/16 Ratcheting Open End: 5/16 Regular Box End: 1/4, 5/16, 3/8, 7/16, 1/2, & 9/16 Ratcheting Box End:...

Dykem Cross Check Torque Stripe

We have this torque stripe in orange only

Reversible Swing Wrenches

These reversible swing wrenches are an improvement over our other wrenches. We are using the reversible Gear wrench brand so when you get into a tight spot and can't get the wrench off the nut or bolt you can simply flip the reversing lever and back out...

Brass Screwdriver For Compass Adjustment

No more trying to make a screw driver for adjusting compasses with a hammer and welding rod.This is a quality, solid brass screwdriver made especially for adjusting compasses.It's 4 3/4 inches long and the blade tip is 5/32" wide.

Grease Fitting - Straight

These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.

Grease Fitting - 90°

These are the threaded ones, not the quick disconnect ones that get grease everywhere except the part you want it in.

90° Grease Coupler

I recently found this 90 degree grease coupler that works great on hard to access grease fittings.Works really well on the oil cooler blower bearings on the Bell 407. It slides in from the side when straight on access is difficult or next to impossible.

Torque Adapters 1/4" Drive

Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter.   SAE: The standard set consists of 1/4", 5/16", 3/8", &...

Rolls-Royce RR300 Seal Installer

This is the new seal installer from Rolls-Royce's Commercial Service Letter. This was designed for installing the new lip seals (23091467) which include a supplied installation mandrel.

52 inches long X 14 inch Drive Extension

​This extension is to R&R the 2 AN-3's inside the tail boom that hold the support for the tail rotor driveshaft.​It comes with a 3/8" 12 point socket with a magnet inside to hold the bolts in place.You no longer need to use multiple...

Rolls-Royce 300 Aft PTO Seal Installer

Name describes it all.

Rolls-Royce 300 PTO Seal Remover

Name describes it all.

R22 & R44 Fan Driveshaft Flange Puller

Easily remove the driveshaft flange for inspections with this work aid.

Robinson Teeterbar - R22 only

Robinson Teeterbar - R22 onlyP/N: HWAMT354-1

Robinson Teeterbar - R44 & R66

Robinson Teeterbar - R44 & R66​P/N: HWAMT354-4

Spindle Boot Plate

Sheave Alignment Bar

Sheave Alignment Bar, I'm a Bell guy, hopefully you already know what this is. MT331-4

Robinson Spark Plug Ignition Cable Wrench

Robinson R22 Clutch Micro Switch Swing Wrenches

1/4 in box end with a 3/8 in open end swing wrench for adjusting the clutch micro switch.

Robinson R22 - Rotor Head Bolt Stretch Gauge

Robinson R22 - Rotor Head Bolt Stretch Gauge  P/N: HWAR22MRSTRETCH      Does not come with dial indicator.  Can be purchased separately. 

Robinson R44 - Rotor Head Bolt Stretch Gauge

Robinson R44 - Rotor Head Bolt Stretch Gauge  P/N HWAR44MRSTRETCH   Does not come with dial indicator.  Can be purchased separately.