206 Series Tail Rotor Crosshead Remover Used to remove the tailrotor crosshead on Bell 206 series aircraft.Safer and faster than the 2 jaw pullers. MSRP: Was: Now: $295.00 Add to Cart
206 Tail Rotor Balance Wheel Adapter No longer will you have to use a flathead screwdriver and mallet to unscrew the balance wheel. Can also be used for torquing when the 1/4" drive cutouts on the balance wheels are worn and won't hold the torque wrench. MSRP: Was: Now: $40.00 Add to Cart
206 Knurl Nut Wrench This will easily remove that stuck knurl nut. It is especially great if you want to replace the knurl nut liner and don't want to ruin the knurl nut with channel locks because the knurl nut is frozen. MSRP: Was: Now: $130.00 Add to Cart
206 Tail Rotor Flap Stop Work Aid This item is 3D printed, made out of PLA. Color may vary. This work aid was designed to replace the Bell designed fork shaped lockout work aid. The 206 tail rotors are shimmed between the tailrotor hub and flap stop. That means every tailrotor is... MSRP: Was: Now: $195.00 Choose Options
206 Tail Rotor Hub Trunnion Fixture Fills in the trunnion, so it is not crushed during pressing of wear sleeves. MSRP: Was: Now: $50.00 Add to Cart
407 Tail Rotor Mast Nut Wrench Use this wrench to torque and perform torque checks of the 407 tailrotor mast nut. Pull quick release pin and slide wrench onto mast nut. Use 3/8 drive torque wrench. This wrench fits better than the large bulky crowsfoot. Send us a scrap tail... MSRP: Was: Now: $275.00 Add to Cart
407 Tail Rotor Flap Stop This work aid is used to stop the tail rotor from flapping when checking the blade pitch angles. This is used in conjunction with the 407 tailrotor rigging block which is used to check the pitch angle. This is our lightweight 3D printed... MSRP: Was: Now: $285.00 Add to Cart
429 Tail Rotor Mast Nut Wrench Remove one of the allen screws and spread open the work aid. Close it back together and reinstall the screw. Torque the nut and then remove the screw and work aid. Almost as fast as reading this description. Does not require removal of crosshead. MSRP: Was: Now: $325.00 Add to Cart
S76 Tail Rotor Crosshead Remover Installs on the crosshead in a matter of seconds by one person instead of several minutes and two people as the factory puller requires. Removes the crosshead at a fraction of the price of the factory tool.Made from 6061 aluminum so it will not... MSRP: Was: Now: $910.00 Add to Cart
S76 Tail Rotor Cable Bullets These have both left hand and right hand threads to aid in removing and installing the aft tailrotor cables. Screw on the cable ends and thread .020 safety wire through the holes drilled in the end. For AFT cables only. MSRP: Was: Now: $65.00 Add to Cart
S76 Tail Rotor Pitch Change Bearing R&R Work Aid Saves time and slowly presses the bearing in or out. You don't need a hydraulic or arbor press. You don't beat it in/out with a hammer. The risk of damaging a part when using a hammer is so great it's a no-brainer. The cost of one damaged tail rotor or... MSRP: Was: Now: $165.00 Add to Cart
