Rolls-Royce 250 Fuel Nozzle Holding Fixture Another one where the name of the tool describes it beautifully. Rolls-Royce P/N 6897875 MSRP: Was: Now: $690.00 Add to Cart
Torque Adapters 1/4" Drive Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter. SAE: The standard set consists of 1/4", 5/16", 3/8", &... MSRP: Was: Now: $50.00 - $170.00 Choose Options
S76A Main Driveshaft Wrench 2pcs set Consists of 2 wrenches, one for the front coupling and another for the aft coupling. Does not include ratchet, extension or socket. Makes driveshaft R&R quick and easy and avoids spilling blood all over the transmission deck.On the A... MSRP: Was: Now: $210.00 Add to Cart
S76 PTO Shaft Wrench When removing or installing the PTO shaft on the C30 engine you need this fixture to hold a backup on the shaft and also to apply the correct torque so the PTO gear is not over torqued and cracked. MSRP: Was: Now: $110.00 Add to Cart
Turbomeca Engine Oil Filter Wrench Turbomeca engine oil filter wrench to remove the housing cap on the S1 or S2 engine. MSRP: Was: Now: $325.00 Add to Cart
Rolls-Royce 250 Banjo Oil Fitting Wrench Allows you to tighten the banjo fitting with a ratchet or torque wrench. Makes removal a piece of cake too. S76A only. MSRP: Was: Now: $70.00 Add to Cart
Turbomeca 2S1 Oil Drain Oil drain for the Turbomeca engine. There are 2 types that I have seen so far. MSRP: Was: Now: $105.00 Add to Cart
Turbomeca 2S2 Oil Drain Oil drain for the Turbomeca engine. There are 2 types that I have seen so far. MSRP: Was: Now: $105.00 Add to Cart
S76C Main Driveshaft Alignment Rod Used to check the main drive shaft alignment when changing engine mounts or any time an alignment problem is suspected. Normally companies furnish this rod but too often it doesn't make it back to the right place in the tool crib so when you need it, it... MSRP: Was: Now: $55.00 Add to Cart
Oil Can Opener One Black Plastic "Church Key" FOD Free Turbine Oil Can Opener MSRP: Was: Now: $7.00 Add to Cart
Rolls-Royce 250 PTO Seal Remover Used to remove single lip PTO seal on RR250 engines. Thread into the seal and use slide hammer to remove. MSRP: Was: Now: $525.00 Add to Cart
