Torque Adapters 1/4" Drive Hard to find 1/4" drive torque adapters. Most torque adapters you will find are 3/8" drive. These will allow you to use that low torque 1/4" torque wrench without the 3/8" to 1/4" adapter. SAE: The standard set consists of 1/4", 5/16", 3/8", &... MSRP: Was: Now: $50.00 - $170.00 Choose Options
S76 Tail Rotor Crosshead Remover Installs on the crosshead in a matter of seconds by one person instead of several minutes and two people as the factory puller requires. Removes the crosshead at a fraction of the price of the factory tool.Made from 6061 aluminum so it will not... MSRP: Was: Now: $910.00 Add to Cart
S76 Tail Rotor Cable Bullets These have both left hand and right hand threads to aid in removing and installing the aft tailrotor cables. Screw on the cable ends and thread .020 safety wire through the holes drilled in the end. For AFT cables only. MSRP: Was: Now: $65.00 Add to Cart
S76 Tail Rotor Pitch Change Bearing R&R Work Aid Saves time and slowly presses the bearing in or out. You don't need a hydraulic or arbor press. You don't beat it in/out with a hammer. The risk of damaging a part when using a hammer is so great it's a no-brainer. The cost of one damaged tail rotor or... MSRP: Was: Now: $165.00 Add to Cart
S76 Main Rotor Pitch Change Bearing R&R Work Aid Change bearings on the aircraft in just a few minutes. Remove the bolt only on the bearing requiring change. Leave the other end attached. Saves lots of time. MSRP: Was: Now: $325.00 Add to Cart
S76 Rotating Scissors Bearing R&R Work Aid Work aid to press the rotating scissors bearing in and out of the swashplate. Don't waste time chasing sockets that will match up with the OD's and ID's. Not to mention the extensions that get deformed when you beat on them with a hammer while driving... MSRP: Was: Now: $195.00 Add to Cart
S76 Main Rotor Damper Bearing R&R Work Aid Makes R&R of damper bearing a 15 minute job.Change the bearing on the aircraft. No need to remove the damper, bleed, etc MSRP: Was: Now: $235.00 Add to Cart
S76 Trim Tab Gauge S76 Main rotor trim tab gauge. Comes with dial indicator and protective case. MSRP: Was: Now: $2,750.00 Add to Cart
S76 Flight Control Rigging Kit All the pins, spacers, etc that are needed for rigging the S76 model helicopter. Parts and pieces are available separately. MSRP: Was: Now: $1,900.00 Choose Options
